| Inspection Type |
Complaint
|
| Scope |
Partial
|
| Safety/Health |
Safety
|
| Close Conference |
2020-09-10
|
| Case Closed |
2022-03-17
|
Related Activity
| Type |
Complaint |
| Activity Nr |
1657748 |
| Safety |
Yes |
|
Violation Items
| Citation ID |
01001A |
| Citaton Type |
Serious |
| Standard Cited |
19100067 C02 V |
| Issuance Date |
2021-03-05 |
| Current Penalty |
2185.0 |
| Initial Penalty |
3121.0 |
| Final Order |
2021-03-23 |
| Nr Instances |
1 |
| Nr Exposed |
1 |
| Related Event Code (REC) |
Complaint |
| Gravity |
5 |
| FTA Current Penalty |
0.0 |
| Citation text line |
29 CFR 1910.67(c)(2)(v):(v) A personal fall arrest or travel restraint system that meets the requirements in 29 CFR part 1910, subpart I, was not worn and attached to the boom or basket when working from an aerial lift: (a) At the worksite: On or about 9/10/2020, an employee in an Altec bucket truck, model LRV55, serial # 1006CV5610, was exposed to a fall hazard of approximately 10 feet, in that the employee had on a tree climber's belt and not a fall arrest harness while cutting tree limbs. |
|
| Citation ID |
01001B |
| Citaton Type |
Serious |
| Standard Cited |
19100067 C03 |
| Issuance Date |
2021-03-05 |
| Abatement Due Date |
2021-03-30 |
| Current Penalty |
0.0 |
| Initial Penalty |
0.0 |
| Final Order |
2021-03-23 |
| Nr Instances |
1 |
| Nr Exposed |
1 |
| Related Event Code (REC) |
Complaint |
| Gravity |
5 |
| FTA Current Penalty |
0.0 |
| Citation text line |
29 CFR 1910.67(c)(3): Electrical tests had not been made in conformance with the requirements of ANSI A92.2-1969, Section 5: (a) At the worksite: On or about 9/10/2020, the employer used an Altec bucket truck, model # LRV 55, Serial # 1006CV5610, that did not have a periodic dielectric test accomplished before using it. |
|
| Citation ID |
01002A |
| Citaton Type |
Serious |
| Standard Cited |
19100132 A |
| Issuance Date |
2021-03-05 |
| Current Penalty |
2185.0 |
| Initial Penalty |
3121.0 |
| Final Order |
2021-03-23 |
| Nr Instances |
1 |
| Nr Exposed |
1 |
| Related Event Code (REC) |
Complaint |
| Gravity |
5 |
| FTA Current Penalty |
0.0 |
| Citation text line |
29 CFR 1910.132(a): Protective equipment was not used when necessary whenever hazards capable of causing injury and impairment were encountered: (a) At the worksite: On or about 9/10/2020, the employer allowed employees to use a chainsaw without using chaps to prevent leg injuries. |
|
| Citation ID |
01002B |
| Citaton Type |
Serious |
| Standard Cited |
19100135 A01 |
| Issuance Date |
2021-03-05 |
| Current Penalty |
0.0 |
| Initial Penalty |
5461.0 |
| Final Order |
2021-03-23 |
| Nr Instances |
1 |
| Nr Exposed |
1 |
| Related Event Code (REC) |
Complaint |
| Gravity |
10 |
| FTA Current Penalty |
0.0 |
| Citation text line |
29 CFR 1910.135(a)(1): The employer did not ensure that each affected employee wear a protective helmet when working in areas where there is a potential for injury to the head from falling objects: (a) At the worksite: On or about 9/10/2020, an employee was not wearing a protective helmet while cutting tree limbs. |
|
| Citation ID |
01004A |
| Citaton Type |
Serious |
| Standard Cited |
19100180 D03 |
| Issuance Date |
2021-03-05 |
| Abatement Due Date |
2021-03-30 |
| Current Penalty |
2185.0 |
| Initial Penalty |
3121.0 |
| Final Order |
2021-03-23 |
| Nr Instances |
1 |
| Nr Exposed |
1 |
| Related Event Code (REC) |
Complaint |
| Gravity |
5 |
| FTA Current Penalty |
0.0 |
| Citation text line |
29 CFR 1910.180(d)(3): Items listed in this section were not inspected for defects at intervals as defined in paragraph (d)(2)(i) of this section or as specifically indicated including observation during operation for any defects which might appear between regular inspections. (a) At the worksite: On or about 9/10/2020, the crane operator did not perform frequent inspections of the items listed in this section on the Kenworth truck crane, model # 1300, serial # 33332, VIN # 1NKDLB0X81J77637, on a daily or monthly basis. |
|
| Citation ID |
01004B |
| Citaton Type |
Serious |
| Standard Cited |
19100180 D04 |
| Issuance Date |
2021-03-05 |
| Abatement Due Date |
2021-03-30 |
| Current Penalty |
0.0 |
| Initial Penalty |
0.0 |
| Final Order |
2021-03-23 |
| Nr Instances |
1 |
| Nr Exposed |
1 |
| Related Event Code (REC) |
Complaint |
| Gravity |
5 |
| FTA Current Penalty |
0.0 |
| Citation text line |
29 CFR 1910.180(d)(4): Complete inspection(s) of crane(s) were not performed at intervals as generally defined in 1910.180(d)(ii) with a determination made as to whether deficiencies constituted a safety hazard: (a) At the worksite: On or about 9/10/2020, the Kenworth truck crane, model # 1300, serial # 33332, VIN # 1NKDLB0X81J877637, was operated without having received an annual inspection since January 23, 2016. |
|
|
